This technique involves construction of loadbearing columns made from gravel or crushed stones with a vibrator to reinforce all soils in the treatment zone and densify surrounding granular soils. It’s a technique first developed by our company founder, Johann Keller, that we’ve used on thousands of projects since.

Various type of vibrocat

Common uses

Reduce foundation settlement
Increase bearing capacity, allowing reduction in footing size
Increase stiffness
Increase shear strength
Reduce permeability
Mitigate potential for liquefaction
Provide slope stabilisation
Permit construction in-fills
Permits shallow footing construction
Prevent earthquake-induced lateral spreading
Very effective for sand compaction and land reclamation

Process

In the wet top-feed process, the vibrator penetrates to the design depth using the vibrator’s weight and vibrations, as well as water jets located in the tip. The stone (crushed stone or recycled concrete) is then added at ground level to the space around the vibrator created by the jetting water. The stone falls through the space to the vibrator tip, and fills the void created as the vibrator is lifted a few hundred millimetres. The vibrator is then lowered, densifying and displacing the underlying stone. This vibro replacement process is repeated in lifts until a dense stone column is constructed to the ground surface.

The dry bottom-feed process is similar, except that no water jets are used and the stone is fed to the vibrator tip through an attached feed pipe. Pre-drilling of dense strata may be required for the vibrator to penetrate to the design depth.

Vibro rigs can be fully instrumented with an on-board data acquisition system. Data from the system, such as amperage and lift rate, can then be recorded and displayed in real-time alongside specified target values on an in-cab monitor. This monitoring allows the operator to correct any deviations in real-time during the construction process to keep the vibro compaction within project specifications.

Variations on the product include vibro concrete columns where concrete is pumped into the ground through the vibrator, and grouted stone columns where the aggregate is mixed with a cement based grout on installation.

Advantages

A versatile ground-improvement method than can be adjusted to a wide variety of soil conditions and foundation requirements
Offers an economical solution for ground improvement
Can be carried out to almost any depth
Relatively quick execution so subsequent structural works can follow very quickly
Soil improvement enables standard shallow footings which can lead to savings
Environmentally-friendly as uses natural and in situ materials
Extremely quiet with low vibration
Only a small quantity soil has to be removed during the process so avoids the cost of spoil removal associated with continuous flight auger and bored piling systems

Quality assurance

The vibro equipment we use is designed and manufactured by our in-house equipment manufacturer exclusively for use by Keller companies.

In-house quality production manager software enables us to capture and analyse data in real time and valid the performance of the ground improvement being carried out.

A variety of production parameters are generally logged during execution including depth, current, pull down force, uplift/pull down sequence, time and date and element number.

Field trials can also be used to verify column production parameters, along with static load tests, single or group, column material compressive strength tests, and column diameter verification.